Has a remote control connector and switch on the rear panel so units can be connected in series or parallel.
This power supply has a remote control connector and switch on the rear panel, so units can be connected in series or parallel with each other to provide higher voltage, higher current, and higher power output.
https://www.pasco.com/products/lab-apparatus/instrumentation/power-supplies/se-9720#specs-panel
Replacement axles for any of the PASCO dynamics carts.
Replacement short bulbs for the CASTLE Kit (EM-8624A). Can also be used with PASCO Light Bulb Sockets (EM-8630).
Non-threaded and non-magnetic lab rod.
Allows the use of PASCO digital sensors with National Instruments Educational Laboratory Virtual Instrumental Suite.
A sturdy, general-purpose base can support one or two rods, and is ideal for experiment setups that require extra stability.
Clamp two rods at any angle, including parallel to one another. 2-Pack.
This is a replacement 120V AC to 9V DC power supply.
A small support with a low profile that will accept 1/2 inch (12.7 mm) threaded rods. The included threaded steel rod is 25 cm long.
Screw-type base light bulbs that are suitable for use with Light Bulb Sockets (EM-8630).
Non-threaded and non-magnetic lab rod.
